The ClearMask task is used to add and edit arguments for the ClearMask command used in a logic template. Performing a ClearMask task consists of the following steps:

Step 1

The first step is to initiate the task by either selecting the Attributes->Clear Mask task in the FILTERING task bar along the left side of the Logic Template editor or by double-clicking on the ClearMask command name in the logic template if a ClearMask already exists. If the Attributes->Clear Mask task is not enabled, be sure there is at least one attribute data field defined in the related load definition file for this logic template.

The ClearMask dialog box will appear:

Step 2

The second step is to specify the Attribute ID for the command:

Use the Attribute ID to select the ID of the attribute selection mask being cleared.

Step 3

The third step is to click the OK button to insert the command into the logic template:

The command is inserted into the logic template where the cursor is located. If the task was initiated by double-clicking on the command name, then the arguments that are changed will be overwritten.